HOSE END FITTING STRAIGHT -4
FITTING BOLT BANJO WITH WASHERS; 3/8 X 24; -3
JIC MALE TO METRIC MALE ADAPTER -3 AN TO 10 X 1 METRIC INVERTED FLARE
Annular Slave Cylinders may be purchased separately from the slave cylinder kits. The dust cover or bellows is included with the cylinder. Adapters do not require crush washers.
FITTING BANJO -3 EXTENDED HOSE END
MK Series kits include the adapter, cylinder, release bearing for stock or 7-1/4" racing clutch, attaching screws, and line adapters. Hose ends and remote bleed kit must be ordered separately. Size of pressure line (-3 or -4) must be specified so that we can install the correct fitting in the cylinder. For the 5-1/2" or smaller clutch, the special Tilton piston and bearing shown on Page 13 must be ordered. NOTE: This system is attached to the MK transmission with three bolts which thread into three holes encircling the main input shaft seal. If these three holes are missing in your case, a Custom annular slave cylinder system must be ordered.
FITTING ADAPTER -6 TO 1/4 in NPT STRAIGHT
FITTING ADAPTOR 90 DEG 3/8 JIC-1/8 NPT
MK Series kits include the adapter, cylinder, release bearing for stock or 7-1/4" racing clutch, attaching screws, and line adapters. Hose ends and remote bleed kit must be ordered separately. Size of pressure line (-3 or -4) must be specified so that we can install the correct fitting in the cylinder. For the 5-1/2" or smaller clutch, the special Tilton piston and bearing shown on Page 13 must be ordered. NOTE: This system is attached to the MK transmission with three bolts which thread into three holes encircling the main input shaft seal. If these three holes are missing in your case, a Custom annular slave cylinder system must be ordered.
FITTING BRAKE ADAPTER -4 TO 3/8 X 24
DISCONNECT QUICK FOR -3 HOSE USES INV-0202201 AN-3 TO 1/8" PIPE THREAD FITTING