Chain Drive

Differential

Drive Axle Components

MK2 Configurations

Sprockets

TRE Classic Chain Drive Differential

Tripods, Boots and Housings

Shopping cart

There are no products in your shopping cart.

0 Items

Total: $0.00

ITEMS VIEWED

5.5" CARBON CLUTCH, 3 PLATE, POT FLYWHEEL, 900 lb-ft

Pot Flywheel, ultra-high pressure plate, 900/1224 lb-ft/Nm Torque

Item #: INV-36553USG-P

Price: $4,275.00

Quantity

Leave this field blank

27T 1ST MAINSHAFT GEAR 2.20:1 6 DOG LUG

27T 1ST MAINSHAFT GEAR ROCKT 2.20:1 6 DOG LUG

Item #: INV-22E9Z135

Price: $279.00

Quantity

Leave this field blank

BEARING CARRIER, CASTING ONLY

Hewland Part # LD202. Contact for availability

Item #: INV-10202

Price: $2,146.00

Quantity

Leave this field blank

17:26, ratio 1.529

P:D - 17:26, 1.529 Ratio, MK5 Top. NOTE: 1. Staffs and MK 5 1st Gears are not interchangeable. 2. MK5 2nd gears must be shortened .040 to use in Staffs. 3. MK5 top gears can be used in Staffs Atlantic with no modification. 4. 9310 Steel Gears suitable for Atlantic. 5. 8620 Steel Gears suitable up to 160hp. 6. Suitable for both Staffs Atlantic and MK5. TIPS FOR STAFFS: 1. Assemble Layshaft and Pinion Shaft nuts with a drop of locktite to prevent loosening. Torque 115 ft-lb. 2. Tighten the pinion bearing nut to 180 ft-lb. during each gear change. 3. Oil Quantities for a dry gearbox: Road course- 2 quarts, Non-pump gearbox; 1.5 quarts, Gearbox with oil pump. Oval- 3 quarts, Non-pump gearbox; 2.0 quarts, Gearbox with oil pump.

Item #: INV-671726

Price: $341.00

Quantity

Leave this field blank

FSCCA 12-33 Ring and Pinion $600.00

………….BLOW OUT SALE…

Taylor Race Engineering SCCA Formula Enterprise Ring and Pinion. 12-33 .

$600.00 while supply last

Item #: INV-05101004

Price: $600.00

Quantity

Leave this field blank

ANNULAR SLAVE CYLINDER KIT FOR FORMULA FORD 16OO USING 7.25" RACING CLUTCH (TILTON, AP OR QUARTERMASTER)

MK Series kits include the adapter, cylinder, release bearing for stock or 7-1/4" racing clutch, attaching screws, and line adapters. Hose ends and remote bleed kit must be ordered separately. Size of pressure line (-3 or -4) must be specified so that we can install the correct fitting in the cylinder. For the 5-1/2" or smaller clutch, the special Tilton piston and bearing shown on Page 13 must be ordered. NOTE: This system is attached to the MK transmission with three bolts which thread into three holes encircling the main input shaft seal. If these three holes are missing in your case, a Custom annular slave cylinder system must be ordered.

Item #: INV-0200781

Price: $430.00

Quantity

Leave this field blank

SNAP RING KIT STOCK SIERRA

SNAP RING KIT SIERRA STOCK

Item #: INV-22515

Price: $17.00

Quantity

Leave this field blank